PES Membrane Cartridges for Micro Electronics Filtration |
q High Flow Rates And Throughputs Due to a Highly
Asymmetric Pore Structure. q Available in a Wide Range of Absolute Pore Sizes. q 100 Percent Integrity Tested and Pre-flushed . q All Polypropylene Parts, Polypropylene Support
Layer. With Thermal Welding to Minimize Extractables. q Manufactured in a Clean Room Environment (Class
10,000). q All Materials Are FDA Listed for Contact With Food
And Beverages. q Double Skin on An Open Anisotropic Pore Structure.
The High Asymmetrical Pore Structure of Our Membrane Offers a High Dirt
Loading Capacity, Increasing The Filtration Performance to Give Higher
Throughputs And Higher Flow Rates Than Symmetrical Membrane. |
Retention Ratings
|
||
q
0.04,0.1,
0.2, 0.45, 0.65, 0.8, 1.2um (Absolute) |
||
Dimensions
|
||
Length |
q
4" to
40" (101.6mm to 1016mm) |
|
Outer Diameter |
q
68mm |
|
Materials of Construction |
||
Filter Media |
q
Hydrophilic
Polyethersulfone Membrane |
|
Core, Cage |
q
Polypropylene |
|
Support Layers |
q
Polypropylene
Microfiber |
|
O-rings/Gaskets |
q
EPDM, Viton,
Silicon, Teflon Encapsulated Type (BSI Registered) |
|
Operating Conditions |
||
Max. Operating Temperature |
q
80°C |
|
Max. Forward Differential Pressure |
q
4.1 bar @
25°C |
|
Rinse-Up |
||
q
Cartridge
will rinse-up to 18 megohm-cm with a minimum of throughput |
||
Sterilization |
q In situ steam or autoclave to 120°C (30 minute cycles) for a maximum accumulated exposure of 10 hours at
Max. differential pressure 7psi(0.5bar). Alternatively, the Micro-Flow may be
sanitized with compatible chemical agent. |
MFN Product Name |
0.2- Retention Rating |
10- Cartridge Length |
3 End
Configurations |
E Materials
of O-rings/gaskets |
Micro-Flow |
0.04,0.1, 0.2, 0.45, 0.65, 0.8, 1.2um Absolute |
4", 10", 20", 30", 40" |
No Symbol= Double open end 3 = SOE flat closed end, External 222 O-rings 8 = SOE fin end, external 222 O-rings 7 = SOE fin end, external 226 O-rings |
E = EPDM V = Viton S = Silicon F = Teflon Encapsulated Type |